Funded under the National Recovery and Resilience Plan (NRRP), Mission 4 Component 2 Investment 1.3, Theme 10.
Grosso, A. L., Morozova, K., Ferrentino, G., Biasioli, F., & Scampicchio, M.
Talanta, 2024, 270, 125513
Acrolein is a toxic volatile compound derived from oxidative processes, that can be formed in foods during storage and cooking. This study employs proton transfer reaction mass spectrometry (PTR-MS) to detect acrolein precursors in vegetable oils by focusing on the m/z (mass-to-charge ratio) 57. To this purpose, hempseed, sesame, walnut, olive and linseed oils were stored for 168 h at 60 °C in presence of 2,2′-azobis(2-metilpropionitrile) (3 mM) radicals initiator. The evolution of m/z 57 by PTR-MS was also compared with traditional lipid oxidation indicators such as peroxide value, conjugated diene, oxygen consumption and, isothermal calorimetry. The obtained results were explained by the fatty acid composition and antioxidant capacity of the oils. Hempseed fresh oil presented a very low total volatile organic compounds (VOCs) intensity (5.6 kncps). Nonetheless, after storage the intensity increased ∼70 times. A principal component analysis (PCA) confirmed the potential of m/z 57 to differentiate fresh versus rancid hempseed oil sample. During an autoxidation experiment oils high in linolenic and linoleic acids showed higher m/z 57 emissions and shorter induction times: linseed oil (38 h) > walnut oil (47 h) > hempseed oil (80 h). The m/z 57 emission presented a high correlation coefficient with the total VOC signal (r > 0.95), conjugated dienes and headspace oxygen consumption. A PCA analysis showed a complete separation of the fresh oils on the first component (most significant) with the exception of olive oil. Walnut, hempseed and linseed oil were placed on the extreme right nearby total VOCs and m/z 57. The results obtained highlight the potential of PTR-MS for the early detection of oil autoxidation, serving as a quality control tool for potential acrolein precursor emissions, thereby enhancing food safety in the industry.